Decal for making resin parts.
Put resin on design and cure to UV/UV-LED light.
"Lace" is designed to fit on 4 kinds of setting and soft mold "jewelry".
Pour color resin in setting and cure with UV light. Put clear resin slightly onto it.
Cut a decal in proper size and place onto the resin. Take air out and cure it again.
Peel oﬀ the ﬁlm slowly.
Pour plenty of resin until swelling and cure it again.
Pour resin about a half of the mold and cure it. Add a little resin, set a decal face down, and cure it.
Pour resin for full covered. Cure again.
Cover with color resin and cure it.
Put resin on each design from back side of a decal.
Cure them and become resin parts.