Tafrect Mold®［Key Tag］

Mold , New , Resin Supplies

Design registration pending
* “Tafrect®” and “Tafrect Mold®” are registered trademarks of PADICO Co., Ltd, registered in Japan.

#403418
JAN：4902498734183
Mold size：W130mm×H130mm×D4.5mm
Package size：W150mm×H200mm×D5mm
Gross Weight：approx. 27g（mold approx. 25g）
Color：translucent
Material：Thermoplastic resin
Upper temperature limit：100~120°C
Cold temperature limit：ー20°C
Storage condition：Place out of direct sunlight.

Made in Japan
Release：November 21st, 2025

1,200 JPY

Decorate with Plates & Parts - Now with Two New Types!
Oval & Rhombus Plate Mold includes 4 simple plate designs and 27 parts with sports and music instrument motifs.

Features
・4plate shapes (oval, rhombus, etc.) + 27parts(sports, instruments, etc.)
・Small parts about 1 cm—easy to decorate!
・Beautiful clear finish with resin.
・Perfect for keychains and accessories.

About new plastic material 「Tafrect®」

  • ・Both plates and parts are 3mm thick. Base parts only are up to 2mm thick.

Important Notes

・Remove bubbles with a stick before curing.
・Shapes may distort slightly.
・Small works: keep out of reach of children(risk of swallowing or injury).
・For craft use only(resin, clay, etc.). Not for food.
・Keep away from direct sunlight & heat. It may deform.
・Remove works only after cooling.
・Repeated use while hot may cause cloudiness or detormation.
・Do not use in microwave or oven.
・Mold surface may have fine scratches (material characteristic).
・Do not use solvents, oils, metal spatulas, or cutters.

How to Use

Place a work sheet (or black paper) under the mold to see the shapes clearly.

Black Work Sheet
[Work Sheet] Download
Making Parts with Colored Resin

①Put UV-Resin and colorant into a mixing palette, and stir well with a stick to create colored resin.

②Put the colorant little by little with the stick.
Gently tap the corners of the mold with a stick to remove air bubbles, as they tend to form easily.

③Finaly, fill to the rim with UV-LED Resin and cure thoroughly. After cooling slightly, gently remove from the mold.

Extra: Drawing on Parts or Plates with Pens

①Fill the mold with clear resin, cure with light, let it cool slightly, and gently remove.

②Draw or color on the front or back surface with a pen.

③Once the ink has dried, coat lightly with resin and cure again for a grossy finish.

Pens You Can Use
●Pigment markers(Copic Acrylica, POSCA,etc.)　●Resin Pens
Some pens may not write smoothly on cured resin.
Not all pens have been tested.

Use Copic Acrylica

How to Decorate Plates

①Make a plate with UV-LED Resin (same as "making parts").

②After curing, remove plate and parts.
Glue parts on the plate.
Once dry, coat with resin for a glossy finish.

How to Use Base Parts*

*The mold includes areas to make base parts.

①Make accessory base parts with resin.

②Attach it to the back of parts with a little resin as shown in the drawing.
Coat the entire back and cure it again.

【Club-Themed Keyholder】

VIEW DETAIL
Go Back