Flower Plate Key Charm

Products'information based on August, 2025.

【Material / Tool】
"Sky Drop" UV-LED Resin
Tafrect Mold ＜Wave＞
Jewel Color for UV & UV-LED Curing Resin
〈White, Strawberry Milk, Melon Sherbet〉
Mixing Stick
Jewel Color Mixing Palette〈Size-S, Mini〉
UV-LED Light
Half Round Pearls [3mm]
Round Jump Rings
Keychain Fitting
Adhesive
Stainless Tweezers
Flat Nose Pliers

  1. 1.

    Put Sky Drop Resin and colorant "Strawberry Milk" into a mixing palette (S size), and stir well with a stick to create redish colored resin.

  2. 2.

    In two mini mixing palettes, mix Sky Drop Resin separately with Jewel Color "White" and "Melon Sherbet".

  3. 3.

    Fill the rim of the mold with the red resin from step 1.

  4. 4.

    Cure under a UV-LED light for a minute.

  5. 5.

    Fill the mold to the top with clear resin.

  6. 6.

    Cure for 1 minutes, then flip and cure for another 1 minute. Remove from the mold.

  7. 7.

    For the tulip motif, fill halfway with red resin. Cure 30 sec.

  8. 8.

    Fill stem and leaves halfway with green resin. Cure 30 sec.

  9. 9.

    Fill to the top with red resin. Cure 30 sec. Fill stem and leaves to the top with green resin. Cure 1 min, flip and cure another 1 min.

  10. 10.

    For the ribbon motif, fill with white resin, cure 1 min, flip, cure another 1 min. Make two pieces.

  11. 11.

    On the plate from step 6, glue the tulip and ribbons. Decorate the rim with half-round peals.

  12. 12.

    Attach a keychain fitting with a jump ring to finish.

Go Back