Innovated crank eyebolt.
Easy to set an accessory with.
Set a crank eyebolt at the edge of the mold and get exposed. No need to drill a hole with a tool.
use eye pin Sink as one's hands be taken oﬀ.
use crank eyebolt Just place it. No sink.
Eye pin needs to stay with tape.
The crank eyebolt stay at the edge without tape.
Set a crankeyebolt at the edge of the mold and get exposed.
No need to drill a hole with a tool.
use an eye pin
There is a gap on the pin
use crank eye bolt
Stick without gaps.
The 0.2 ‒ 0.3mm thin plate does not aﬀect pasting two parts.
See how tinny part the eyebolt fit in the snow crystal mold.
Cut oﬀ extra tip of the eyebolt to ﬁt in the mold.
Pour resin into mold and set the eyebolt.
Expose to UV light. Take the piece out of mold.