Products

Brand-New Products

Water Drop 3D Silicone Mold

Soft Mold

#403268
JAN:4902498732684
Mold Size:54×37×18mm
Net weight:20g
Package size:90×150×19mm
Gross weight:23.5g
Silicone mold for 10x15mm size water drop with a hole/ 10×15.5mm sized water drop without a hole, and 4Φ×7mm sized eyebolt 1 pc in a package
Use:Resin Craft
Upper limited temperature:200℃
Lower limited temperature:-50℃

1,000 JPY

・Two types of drop:one has a hole inserting accessory parts, the other is a simple shape of drop without the hole.
・Flexible silicone rubber mold can be used for the reproduction of jewelry shaped objects.
・Eyebolt shaped mold is attached for the resin eyebolt.
・Approximately 1 gram resin needs for one drop.

Tips for making beautiful drop

Pour resin not up to the edge of the mold to avoid burrs.
First 1-2 drops of resin for covering the narrow top. Use a stick to take bubbles out.

How to reduce burr on the drop

Use sandpaper #600 to deburr. Fill resin in a recess.
Rub with sandpaer again and cover it with gloss coat.

Side View

  • Drop shape with an accessory insert

  • Simple waterdrop shape

  • resin made eyebolt

※Due to a small curing shrinkage, sizes are only guides.

How to Use

  • Pour resin little by little up to just below the spout. Do not speard it to the out. Get rid of bubbles by sticking a toothpick. Cure it under the UV-LED lamp.
    ※Turn the mold over and cure it again with LED light.

  • Push the resin out from its back after cooling down.
    ※The resin has high temperature just after exposed. Please be careful.

  • Fill a hollow part with a small amount of resin and cure to make its shape round.

  • Set an eyebolt
    Paste resin on eyebolt and insert it. Cure it again. It can be fasten with glue.

Next
Prev

Follow us!