Products

Jewel Labyrinth

Silicone mold <Flower Cabochon>

Mold

Release on July 03, 2020

#403288
JAN:4902498732882
1pc
Color:semitransparent
Gross weight:30g
Raw material:Silicone rubber
Mold size:W80×H60×D10mm
Package size:W120×H155×D11mm
Heat proof temperature:200℃
Cold resistance:-50℃

1,350 JPY

・3D & semi 3D shaped lilies of the valley, margaret, hydrangea, leaves, and birds.
・Use as a resin mold and as clay one.
・Beautiful resin surface without coating.

How to Use

as a clay mold

  • Grease the mold with mold oil(#404125). It is okay with any modeling clay. Modena resin clay is used in the instruction.

  • Take a proper amount of clay and put in the mold.

  • Press from the back and remove it from the mold.

  • Make 4 petals and glue them as a flower.

as a resin mold

  • Make preferred colored resin. Salmon pink color is for this instruction.

  • Pour the resin into the mold until it reaches the very limited to the top.

  • Cure it under UV-LED light.

  • Cool down the mold and push the piece out.
    The chemical reaction can generate heat, take care not to burn yourself.

How to make a 3D lily of the valley

  • Make white color resin. Pearl white is used for this instruction.

  • Put a fine drop of the resin into the 3D mold with a stick. Repeat it 3 times.

  • Stir it 10 times with a needle to let the resin reach to every edge in the mold.

  • Fill the mold half-full with resin.

  • Pinch the mold with two fingers 10 times.

  • Fill the mold full with resin.

  • Set a 9 pin on a stick and dip it to the mold.

  • Cure the mold and make sure the pin is affixed.

  • Cool down the mold and push the piece out from the 3D mold.

  • Add a stick of the resin on a dimple around the pin and cure with UV-LED light.

  •  

Next
Prev

Follow us!